Design and simulation of an integrated circuit for the control of a PAP motor, using VHDL programming

Authors

  • Darío Utrilla Salazar Facultad de Ingeniería Eléctrica y Electrónica, Universidad Nacional de Ingeniería. Lima, Perú.

DOI:

https://doi.org/10.21754/tecnia.v16i2.392

Keywords:

digital design, FPGA, VHDL

Abstract

This report describes the design of an integrated circuit developed to control stepper motors (PAP), using an FPGA device, obtained through VHDL programming and advanced digital design techniques. First, the basic characteristics of stepper motors are presented, then the procedures carried out, starting with the description of the control environment used. Next, the design of the integrated circuit for the control of the stepper motor and its implementation in an FPGA through advanced digital design tools are detailed. Finally, the simulations obtained from the design showing its operation are shown.

Downloads

Download data is not yet available.

References

[1] C.B. Gray Longman Sceintific., "Electrical Machines and Drive Systems". Technical 1999.

[2] Nasar Syed A., "Maquinas eléctricas y electromecánicas", Editorial Marcombo Barcelona, 1995.

[3] Martínez, D. G., Alcalá, J., "VHDL El Arte de Programar Sistemas Digitales" Tec. de Monterrey Campus Estado de México, 2005.

[4] Hamblen, J. O., Furman, M. D., "Rapid Prototyping of Digital Systems" Georgia Institute of Technology.

Downloads

Published

2006-12-01

How to Cite

[1]
D. Utrilla Salazar, “Design and simulation of an integrated circuit for the control of a PAP motor, using VHDL programming”, TEC, vol. 16, no. 2, pp. 51–57, Dec. 2006.

Issue

Vol. 16 No. 2 (2006)

Section

Articles

License

Copyright (c) 2006 TECNIA

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Articles published by TECNIA can be shared under the international Creative Commons license: CC BY 4.0. Permissions beyond this scope can be inquired via email at tecnia@uni.edu.pe.