The influence of the ethanol/water molar ratio in the precursor solution on morphology and photocatalytic activity of pyrolytic ZnO films

Authors

  • María Quinta Facultad de Ciencias, Universidad Nacional de Ingeniería. Lima, Perú.
  • Juan Rodríguez Facultad de Ciencias, Universidad Nacional de Ingeniería. Lima, Perú.
  • José L. Sólis Facultad de Ciencias, Universidad Nacional de Ingeniería. Lima, Perú.
  • Walter Estrada Facultad de Ciencias, Universidad Nacional de Ingeniería. Lima, Perú.

DOI:

https://doi.org/10.21754/tecnia.v15i2.426

Keywords:

zinc oxide, photoelectrocatalytic degradation, metil orange, spray pyrolisis

Abstract

Zinc oxide films were fabricated by a home-made spray pyrolysis system equipped with an optical set-up ensuring the in-situ control of the film growth 0.1 M of zinc acetate diluted in a mixture of ethanol and water was used as the precursor solution. The deposition temperature and the pH of the precursor solution were kept at 350°C and 4.5, respectively. X-ray diffraction patterns revealed that films were zincite-like with a grain size depending of the ethanol/water molar ratio, Γ, in the precursor solution. The interference pattern obtained during film deposition was used to monito the film roughness: it was found that this is related with those results of surfaces and optical analysis obtained by scanning electron microscopy (SEM) and spectrophotometric measurements, respectively. Photo-electrocatalytic results indicated that there is a correlation of the partial molar volume of ethanol respect to water in the spraying solution with the photocatalytic efficiency of the ZnO films. We found that the maximum photodegradation of methyl orange in the solution occurs using ZnO films obtained with Γ equal to 0,12.

Downloads

Download data is not yet available.

References

[1] Ollas, D., al-Elkabi, H., "Photocatalytic Purification and Treatment of Water and Air", elsevier, Amsterdam, Holland, 1993.

[2] Fujishima, A., Hasimoto, K., Watanabe, T., "TiO₂ photocatalysis, Fundamentals and applications", BKC, Tokio, Japan, 1999.

[3] Domenech, X., Peral, J., "Kinetics of the photocatalytic oxidation of N(III) and S(IV) on different semiconductor oxides", Chemosphere 38, pp. 1265-1271, 1999.

[4] Pal, B., Sharon, M., "Enhanced photocatalytic activity of highly porous ZnO thin films prepared by sol-gel process", Mater. Chem. Phys. 76, pp.82, 2002.

[5] Jim, M., Shu-Ying, L., "Preparation of ZnO films by reactive evaporation", Thin Solid Films, 237, pp. 16 - 18, 1994.

[6] Krzesinsky, A., "A study of the effect of technological parameters of r.f. sputtering on the size of grains and the texture of thin ZnO films", Thin Solid Films, 138, pp. 111, 1986.

[7] Ristov, M., Sidaninovsky, G. J., Grozdanov, Y., Mitreski, M., "Chemical deposition of ZnO films", Thin Solid Films, 148, pp. 65, 1987.

[8] Tomar, M. S., Garcia, F. J., "A ZnO/p- CulnSe, thin films solar cell prepared entirely by spray pyrolysis", Thin Solid Films, 90, pp. 419-423, 1982.

[9] Cossement, D., Streydio, J. M., "Fabrication of ZnO polycrystalline layers by chemical spray", J. Cryst. Growth 72, pp. 57-60, 1985.

[10] Fahrenbruch, A. L., Bube, R. H., Properties of ZnO films deposited onto InP by spray pyrolysis", Thin Solid Films 136, pp. 1- 10, 1986.

[11] Mayor, S., Banerjee, A., Chopra, K. L., Optical and electronic properties of zinc oxide films prepared by spray pyrolysis, Thin Solid Films 125, pp. 179-185, 1985.

[12] Miki-Yoshida, M., Collings-Martinez, V., amézaga-Madrid, P., Aguilar-Elguézabal, A., "Thin films of photocatalytic TiO₂ and ZnO deposited incide a tubing by spray pyrolysis", Thin solid films, 419, pp. 60, 2002.

[13] Miki -Yoshida, M., Paraguay-Delgado, F., Estrada-López, W., Andrade, E., "Structure and morphology of high quality indium-doped ZnO films obtained by spray pyrolysis", Thin Solid Films, 376, pp. 99 - 109, 1999. films for

[14] Quintana, M., Ricra, Rodriguez, J., Estrada- López, W., "Spray pyrolysis posited zincoxide photo-electrocatalytic degradation of methyl orange: influence of the pH", Catálisis Today, 76, pp. 141, 2002.

[15] Paraguay D., F., Estrada-López, W., Acosta N., D. R., Andrade, E., Miki-Yoshida, M., "Growth, structure and optical characterization of high quality ZnO thin films obtained by spray pyrolysis", Thin Solid Films, 350, pp. 192-202, 2000.

[16] Comina, G., Rodríguez, J., Solis, J. L., Estrada-López, W., "In-situ laser reflectometry measurements of pyrolytic ZnO film growth", Measurements of pyrolytic ZnO film growth", Measurement Science and technology, 16, pp. 685-690, 2005.

[17] Rodriguez, J., Gómez, M., Lindquist, S.-E., Granqvist, C. G., "Photo-electrocatalytic degradation of 4 chlorophenol over sputter deposited Ti oxide films", Thin Solid Films, 360, pp. 250-255, 2000.

[18] Mills, A., Williams, G., "Methyl orange as a probe of the semiconductor-electrolyte interfaces in CdS suspensions", J. Chem Soc., Faraday Trans. 1: 83, pp. 2647 2661, 1987.

[19] Atkins, P. W., "Physical Chemistry, Oxford University Press, Oxford, UK, 1994.

Published

2005-12-01

How to Cite

[1]
M. Quinta, J. Rodríguez, J. L. Sólis, and W. Estrada, “The influence of the ethanol/water molar ratio in the precursor solution on morphology and photocatalytic activity of pyrolytic ZnO films”, TEC, vol. 15, no. 2, pp. 57–65, Dec. 2005.

Issue

Section

Articles

Most read articles by the same author(s)