ZNO nanostructured electrode fabrication for photovoltaic applications

Authors

  • Carlos Ramos Facultad de Ciencias, Universidad Nacional de Ingeniería. Lima, Perú.
  • Anthony Huamán Facultad de Ciencias, Universidad Nacional de Ingeniería. Lima, Perú.
  • María Quintana Facultad de Ciencias, Universidad Nacional de Ingeniería. Lima, Perú.
  • Walter Estrada Facultad de Ciencias, Universidad Nacional de Ingeniería. Lima, Perú.

DOI:

https://doi.org/10.21754/tecnia.v23i2.75

Keywords:

ball milling, zno nanoparticles, current-voltage, ipce

Abstract


Electrodes for Dye Sensitized Solar Cells (DSCs) were made using ZnO nanoparticles deposited over conductive substrates of SnO2:F (FTO). ZnO nanoparticles were obtained by the wet ball milling technique. Then these particles were used to make a viscous paste which was deposited over the substrate by the dr. lade method. After sintering, the electrodes were sensitized with organic and metalorganic dyes like D35 and N719 respectively during 14 hours. Liquid electrolytes with redox mediators like iodide/ triiodide redox cuple and cobalt complexes were used. Also platinum and polymer (PEDOT) covers were used like counterelectrodes. Sealed cells reported efficiencies values as high as 1.6% and values for incident photo conversion efficiency (IPCE) close to 60% at 500nm.

Downloads

Download data is not yet available.

References

[1] O’ Regan, B., Gratzel, M., “A low-cost, high-efficiency solar cell based on dye sensitized colloidal TiO2 films”. Nature, 353, pp. 737 − 740. 1991.

[2] Martinson, A. B. F., Elam, J. W., Hupp, J. T., Pellin, M. J., “ZnO Nanotube Based Dye-Sensitized Solar Cells”. NanoLett. 7, pp. 2183 − 2187, 2007.

[3] Memarian, N., Concina, I., Braga, A., Rozati, S. M., Vomiero, A., Sberveglieri, G, “Hierarchically Assembled ZnO Nanocrystallites for High-Efficiency Dye-Sensitized Solar Cells”. Chem., Int. Ed., 50, pp. 12321 − 12325, 2011.

[4] Tian, H., Yu, Z., Hagfeldt, A., Kloo, L., Sun, L., “Organic Redox Couples and Organic Counter Electrode for Efficient Organic Dye-Sensitized Solar Cells”, J. Am. Chem. Soc., 133, pp. 9413 – 9422, 2011.

[5] Feldt, S., Gibson, E., Gabrielsson, E., Sun, L., Boschloo, G., Hagfeldt, A., “Design of Organic Dyes and Cobalt Polypyridine Redox Mediators for High-Efficiency Dye-Sensitized Solar Cells”, J. Am. Chem. Soc, 132, pp. 16714 –16724, 2010.

[6] Ramos C., Quintana M., Estrada W., “Desarrollo y optimización del proceso de molienda mecánica para la fabricación de nanopartículas de ZnO”, XX Simposio Peruano de Física. Tacna, 2011.

[7] Hagberg, D. P, Jiang, X., Gabrielsson, E., Linder, M., Marinado, T., Brinck, T., Hagfeldt, A., Sun, L., “Symmetric and unsymmetric donor functionalization comparing structural and spectral benefits of chromophores for dye-sensitized solar cells”, J. Mater. Chem, 19, pp. 7232, 2009.

[8] Ellis, H., Vlachopoulos, N., Häggman, L., Perruchot, C., Jouini, M., Boschloo, G., Hagfeldt, A., “PEDOT counter electrodes for dye-sensitized solar cells prepared by aqueous micellar electrodeposition”, Electrochimica Acta 107, pp. 45 - 51, 2013.

Downloads

Published

2013-12-01

How to Cite

[1]
C. Ramos, A. Huamán, M. Quintana, and W. Estrada, “ZNO nanostructured electrode fabrication for photovoltaic applications”, TECNIA, vol. 23, no. 2, pp. 46–51, Dec. 2013.

Issue

Vol. 23 No. 2 (2013)

Section

Articles

License

Copyright (c) 2013 TECNIA

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Articles published by TECNIA can be shared under the international Creative Commons license: CC BY 4.0. Permissions beyond this scope can be inquired via email at tecnia@uni.edu.pe.

Most read articles by the same author(s)